MJX B2W RC Drone Knock Down and Fly Experience

IMG_256

First remove the lamp shade and under the lampshade there is one of the screws will also lock the shell so first remove the chimney best.

Found a problem here the chimney screw twist the flat on the original position after coming out but there is one side will become warped. The manufacturers must improve the mold after so long time to pull don’t know will have crack though not what activities are needed, but it is a problem.

IMG_257

Break out after the GPS and the compass will pull the plug, must have to draw it out, it is worth noting that the GPS and the compass is used in MJX GH1.25 mm plug, and with 704 silicone, I are suggested with hot melt adhesive, more convenient.

IMG_258

Take down the overall effect of the picture above, and feel it.

IMG_260

Both the compass and GPS of the fuselage are shielded from the large current and prevent interference

The GPS is not seen and it seems to be custom.

IMG_261

IMG_262

IMG_263

Check out the compass module, also known as the magnetic compass

IMG_256

The single chip in flight control is arm32-bit STM32F103, which is sufficient for B2W.

IMG_258

This black box is of IMU module like Dji and other companies with ribbon cable to connect to the master and covered with simmons figure pass and receiving modules are double brass antenna, MJX hin for equipment materials really quite good, this figure has a slot antenna fixed and the hot melt adhesive.

IMG_260

The camera doesn’t see which chip it is which is connected to the graph by line.

IMG_264

Below we remove the remote control, this time get the remote control and feel the remote control of B2W is more than the level of B3 and feel very good that not know where is the mystery.let us look for it.

IMG_256

Discovered the sides had seen under the cover of two slots, unscrewed the screw see two iron was found, it should be for the sake of balancing the weight of the phone, may I remote control after heavy accustomed to take B3 is very uncomfortable, the counterweight B2W feels more high-end.

IMG_258

IMG_259

In the last battery there is no difference between the core and B3 except the power line and the battery box.

IMG_256

The XT30 pin hole position on the battery box is still very accurate. After covering the cover, it will be found that something will resist the drop off of the XT30. This design is still very good.

IMG_257

The battery can be taken out of the battery, so that the battery can plug the battery.

IMG_260

The map of B2W has been used for the transmission of 5G wifi. The owner’s mobile phone was purchased in 2014, and there is no problem with it. Therefore, it is speculated that this B2 chart can be adapted to the majority of mobile phones in the market.

The distance from the map is completely negative…

I have tested the following conditions under the conditions of excellent conditions (only B2wifi exists in the environment) and can still reach the unkaton at the distance of 220 meters, and the delay is only half a second.

But in most complex environments, it is almost possible to have a case of carton and delays in 200 or so, but the degree is acceptable.

In the case of excellent conditions, the limit distance of the drawing is 672 meters. Then it will be completely jammed!

Actually as a wifi map, the individual feels that this effect should be good!

At the same time, the resolution of 720P from 5G is really good and it is very clear with mobile phone!

IMG_257
IMG_258
IMG_259
IMG_260
IMG_261
IMG_262
IMG_263
IMG_264

4 Comments

  1. This was exquisite fun to try to understand–it’s almost as if each word of another language was translated on the fly making it appear to be English but the syntax that of the other language…

    Please paste more images! (So I can resist disassembling my own Bugs 2w!)

Leave a Reply

Your email address will not be published.


*